Jump to main content.


GEOEAS

See Also

Description

GEOEAS is a collection of interactive software tools for performing two-dimensional geostatistical analyses of spatially distributed data. The principal function of the package is the production of grids and contour maps of interpolated (kriged) estimates from sample data. GEOEAS can produce data maps, univariate statistics, scatter plots/linear regression, and variogram computation and model fitting.

Specifications

Version 1.2.1
Release Date April 1991
Development Status general release
Development Information  
Operating System UNIX, DOS
Development Language  
Intended Audience  
Key Words  
Related Web Sites  

Minimum System Requirements

This system was designed to run under DOS on an IBM PC, XT, AT, PS2, or compatible computer. Graphics capability is not required, but is highly recommended because most programs will produce graphics output. Graphics support is provided for the Hercules graphics card, the CGA, and the EGA. At least 512 KB of RAM is required, but 640 KB is recommended. An arithmetic co-processor chip is strongly recommended due to the computationally intensive nature of the programs, but is not required for use. Programs may be run from floppy disk; however, a fixed disk is required to use the programs from the system menu. The system storage requirement is approximately 3 MB. For a hardcopy of results, a graphics printer (IBM graphics compatible) is required. Support is provided for plotters that accept HPGL plotting commands.

Downloads

Unzipping Software Exit EPA disclaimer

You will need unzipping (compression) software to uncompress ZIP files. If you need to load unzipping software on your computer, free software is available for download on the internet at the following sites:

Executable and program files (ZIP) (14 files, 1.3 Mb)

US EPA. (1991) "GEO-EAS 1.2.1, Geostatistical Environmental Assessment Software User’s Guide," Publication No. EPA/600/4-88/033.

Installation Instructions

  1. Refer to the user’s manual for further instructions.
  2. Go to Windows Explorer and create a directory named GEOEAS.
  3. Download the executable and program files to the new directory.
  4. From the new directory, run geoeas.zip by double-clicking on the file.
  5. Unzip the files to the new directory.
  6. Download and review the user’s manual for instructions on running the model.
  7. Start the GEOEAS program by double-clicking on the GEOEAS.EXE file. A description of other executable files that are part of the GEOEAS program are as follows:

    GEOEAS.EXE – the system menu program
    DATAPREP.EXE – data management utilities
    TRANS.EXE – data transformations
    STAT1.EXE – basic univariate descriptive statistics
    SCATTER.EXE – scatter plots, linear regression
    PREVAR.EXE – pair comparison computations
    VARIO VARIO.EXE – variogram analysis and modeling
    XVALID.EXE – cross validation of parameters
    KRIGE KRIGE.EXE – two-dimensional kriging
    CONREC.EXE – contouring of gridded data
    POSTPLOT.EXE – graphs of sample locations and values
    XYGRAPH.EXE – two-dimensional line/scatter graphs
    VIEW.EXE – plots graph files on the screen
    HPPLOT.EXE – creates plotter files from graphic metafiles

You will need Adobe Reader to view some of the files on this page.
See EPA's PDF page to learn more.

 

Office of Research & Development | National Risk Management Research Laboratory


Local Navigation


Jump to main content.