Installing the System
To install the PRZM-2 model system and/or related support files on a hard disk, insert the first distribution diskette in a compatible diskette drive (refer to section 2.4). Then type
A: \INSTALL or B: \INSTALL
at the DOS system prompt and press the <Enter> key. Then follow instructions and respond to prompts presented on the monitor screen by the interactive installation program. Complete installation instructions are also printed on each external diskette label.
NOTE: To install the PRZM-2 model system and/or related support files on a hard disk from an interactive, self-extracting installation program down loaded from the CEAM BBS or through Internet, type
at the DOS system prompt then press the <Enter> key. This assumes that the current default drive and sub-directory is the same as the drive and sub-directory where the file INSTALP2.EXE is stored. Then follow instructions and respond to prompts presented on the monitor screen by the interactive installation program. The PRZM-2 distribution diskette sets and BBS files implement software product installation standards to insure the most error-free, maintainable, and user-acceptable distribution of CEAM products. It has a unique menu option, command, full-screen (interactive), diagnostic, error-recovery, help, and selective installation capabilities using state-of-the-art human-factors engineering practices and principles.
NOTE: The contents of the distribution diskettes can be copied to another set of "backup" diskettes using the DOS DISKCOPY command. Refer to the DOS Reference Manual for command application and use. The "backup" diskettes must be the same size and storage density as the original source diskettes.