Jump to main content.


EPA Map of Radon Zones

South Carolina
 

EPA Map of Radon Zones
The purpose of this map is to assist National, State, and local organizations to target their resources and to implement radon-resistant building codes. This map is not intended to be used to determine if a home in a given zone should be tested for radon. Homes with elevated levels of radon have been found in all three zones. All homes should be tested regardless of geographic location.  Important points to note:
 

The Map was developed using five factors to determine radon potential: indoor radon measurements; geology; aerial radioactivity; soil permeability; and, foundation type. Radon potential assessment is based on geologic provinces. Radon Index Matrix is the quantitative assessment of radon potential. Confidence Index Matrix shows the quantity and quality of the data used to assess radon potential. Geologic Provinces were adapted to county boundaries for the Map of Radon Zones.

Sections 307 and 309 of the Indoor Radon Abatement Act of 1988 (IRAA) directed EPA to list and identify areas of the U.S. with the potential for elevated indoor radon levels. EPA's Map of Radon Zones assigns each of the 3,141 counties in the U.S. to one of three zones based on radon potential:

zone 1 Zone 1 counties have a predicted average indoor radon screening level greater than 4 pCi/L (pico curies per liter) (red zones) Highest Potential
zone 2 Zone 2 counties have a predicted average indoor radon screening level between 2 and 4 pCi/L (orange zones) Moderate Potential
zone 3 Zone 3 counties have a predicted average indoor radon screening level less than 2 pCi/L (yellow zones) Low Potential

South Carolina Zone Map

IMPORTANT: Consult the EPA Map of Radon Zones document (EPA-402-R-93-071) before using this map.  This document contains information on radon potential variations within counties. EPA also recommends that this map be supplemented with any available local data in order to further understand and predict the radon potential of a specific area. If you have questions about radon in water, see www.epa.gov/radon/rnwater.html or contact your State Radon Coordinator.

Top of page

EPA Recommends: Test your home for radon -- it's easy and inexpensive; Fix your home if your radon level is 4 picoCuries per liter (pCi/L) or higher. Radon levels less than 4 pCi/L still pose a risk, and in many cases may be reduced.

About the Indoor Environments Division | Where You Live | Site Index


Local Navigation


Jump to main content.

html>