Jump to main content.


Selecting and Evaluating Environmental Attributes

Cleaning Products Pilot Project (CPPP)

CPPP Home
Introduction
Project History
Project Status
Lessons Learned
Stakeholders
Glossary

Following the completion of the Philadelphia pilot project, EPA initiated a comparative risk management assessment of the 19 cleaning products, known as an RM1 assessment. (An RM1 is a preliminary risk management assessment to determine if the human health or environmental risks associated with product components warrant further investigation. The RM1 conducted as part of the CPPP was different from traditional RM1 assessments because attributes other than those directly associated with risk, like product packaging, were also evaluated.) EPA and GSA encouraged manufacturers to voluntarily provide product formulation data, but this approach was not uniformly successful. As a result, the RM1 relied primarily on publicly available information derived from MSDSs and product literature.

The primary goal of the RM1 was to develop specific environmental attributes that could be used to help assess the environmental preferability of commercially available cleaning products. These attributes included:

EPA encountered several limitations while conducting their comparative assessment of the 19 cleaning products. The limitations included:

As a result, EPA was unable to completely assess the chronic health risks associated with the cleaning products, although it is hoped that these risks can be quantified in future phases of the CPPP.

EPA also chose not to include the presence of ozone depleters or energy needs in its assessment because none of the 19 cleaning products included ozone-depleting compounds or specified hot water use. Following the RM1 assessment, EPA determined that flammability did not differ significantly among the cleaning products and, therefore, recommended that flammability be excluded as an environmental attribute under the Cleaning Products Pilot Project.

Based on the results of the RM1 assessment and other considerations, such as the ability of small vendors to supply the necessary information, EPA narrowed the list of environmental attributes that could be used to identify environmentally preferable cleaning products. In addition to the existing acute toxicity and biodegradability criteria detailed in the Federal Supply Schedule Contract for Biodegradable Cleaners/Degreasers, EPA suggested other attributes including: skin irritation factors, BCF value, VOC concentration, product packaging, use of cosmetic additives, and the likelihood of concentrate exposure.

EPA did not recommend providing government purchasers with the impact of every conceivable environmental attribute for two reasons. First, most of the environmental attributes associated with cleaning products did not differ significantly from one product to another. If new cleaning products are introduced that differ from other cleaners in an important environmental attribute, EPA might recommend including the attribute in a future phase of the CPPP. Second, because the information being examined was to be used by federal purchasers, EPA wanted to avoid over-burdening them with information that would not facilitate their evaluation of the environmental preferability of a given product. The GSA/EPA team determined, based on EPA's recommendations, that information that fails to distinguish one product from another is not useful for comparing environmental preferability.

Previous (EPA's Environmentally Preferable Guidance)

Next (The Great Compromise)


Local Navigation


Jump to main content.