Jump to main content.

Naturally-Occurring Radiation: 

Coal Fly Ash, Bottom Ash and Boiler Slag


Burning coal in boilers to create steam for power generation and industrial applications produces a number of combustion residuals. Naturally radioactive materials that were in the coal mostly end up in fly ash, bottom ash and boiler slag. These residuals are called TENORM--Technologically Enhanced Naturally Occurring Radioactive Materials--because burning removes the coal's organic constituents, concentrating the trace amounts of naturally occurring radionuclides:

About 80 to 90 percent of fly ash, bottom ash and boiler slag is non-radioactive minerals, typically silicon, aluminum, iron and calcium.

The table below lists typical radiation levels in fly ash and bottom ash:

Wastes Radiation Level [pCi/g]
  low average high
Fly Ash 2 5.8 9.7
Bottom Ash
1.6 3.5-4.6 7.7

The Radiation in TENORM Summary Table provides a range of reported concentrations, and average concentration measurements of NORM associated with various waste types and materials.

Waste Generation

How Coal Plants Generate Electricity

In a typical coal-fired boiler, coal is burned and the heat is extracted to generate steam. The steam is used to drive a turbine, which in turn, drives an electrical generator. Low pressure steam leaving the turbine is fed to a cooling system which extracts any residual heat and condenses the steam back to water.

Condensed water is collected and recycled back to the boiler where the process is repeated.

In 2012, 59 percent of the coal consumed by electric utilities and independent power producers in the United States resulted in the generation of about 68 million tons of fly ash, bottom ash and boiler slag. An additional 42 million tons of other residuals were generated from flue gas desulfurization and fluidized bed combustion. ( American Coal Ash Association (ACCA) Survey Report (PDF)) (1 p, 94 K About PDF) Exit EPA Disclaimer

Stack filtration devices, such as electrostatic precipitators, baghouses and scrubbers are routinely used to reduce the emission of fly ash. They are about 99 percent effective. Only about one percent is released into the air.

The amount of ash produced depends on the mineral content of the coal and the type of boiler. The typical natural content of minerals in coal used in the U.S. ranges from about 3 percent to 30 percent, with an average of about 10 percent depending upon the region from which the coal was mined. Some utilities are selecting coal with lower mineral (or ash) content to meet particulate emission standards. In other instances, utilities reduce the ash content by washing the coal. Washing can reduce the ash content by as much as 50 to 70 percent.

Disposal and Reuse

The ACCA survey showed that about 45 percent of all fly ash, bottom ash and boiler slag was reused. Its use depended on characteristics of the ash:

The fly ash, bottom ash and boiler slag that was not reused, about 55 percent of the total generated, was disposed in landfills and surface impoundments.

*Portland cement makes up about 10 percent of concrete. Typically 10 to 40 percent of the cement is replaced with fly ash, making the final mix of fly ash in concrete range from one to four percent.

Top of page


Local Navigation

Radiation Home

Jump to main content.