Kennametal Manufacturing -Bedford
On This Page
EPA Project Manager
Mr. Andrew Clibanoff
U.S. Environmental Protection Agency - Region III
1650 Arch Street
Mail code: 3LC30
Philadelphia, PA 19103-2029
Phone: (215) 814-3391
Kennametal has achieved Construction Complete status with controls. The Kennametal Manufacturing facility achieved a “Yes” determination for the Current Human Exposures Under Control Environmental Indicator (EI) and a “Yes” determination for the Migration of Contaminated Groundwater Under Control EI in April 1997.
Kennametal has placed a notice with the Bedford County Court House that describes the environmental conditions at the property. This was done to serve as notice to potential future owners of the property, even though Kennametal has no plans of selling the facility. In addition, Kennametal has implemented a groundwater pump and treat/monitoring program at the facility that will continue until all maximum contaminant levels (MCLs) have been achieved for a period of three consecutive years.
The Kennametal Manufacturing facility is located in Bedford, Pennsylvania in a valley about 1 mile upstream from the confluence of Dunning Creek and Raystown Branch of the Juniata River. The Facility is situated in a rural area characterized by low density residential uses, with some non-residential land uses (e.g., commercial and institutional).
The Facility consists of two manufacturing areas, each with its own distinct functions. In Manufacturing Area 1, the tungsten carbide powders undergo pelletizing, fitzmilling, and pressing of mechanical pill presses into tool tips of various shapes. In Manufacturing Area 2, the steel bodies that hold the tungsten carbide tips are manufactured and undergo brazing to the tungsten carbide tool tips. The steel parts are processed by honing, turning, milling, and drilling, along with some straightening and cutting.
Kennametal Manufacturing is currently implementing remediation of contaminated groundwater at isolated locations within the Facility’s property. The cleanup consists of groundwater pump and treat, and long term groundwater monitoring. Groundwater monitoring results are submitted to EPA for evaluation. Kennametal Manufacturing will continue to perform groundwater remediation and monitoring until the Maximum Containment Levels (MCL) for 1,1,1-Trichloroethane (200 ppb) and 1,1-Dichloroethylene (7 ppb) are achieved for three consecutive years. On June 14, 2002, EPA agreed to allow Kennametal to monitor groundwater on a less frequent basis, once every 15 months for certain wells and once every 30 months for wells that have been yielding consistent results over the past several years. The 12th round of groundwater monitoring was completed in January 2008 and included a sub-set of the wells in the monitoring network. MCL exceedences continue to be observed in monitoring wells MW-1, MW-7, SP-4 and MW-30. The next round of sampling was scheduled for December 2007, but the results of this sampling event were not yet available at the time of this update.
Primary areas of concern are 1,1,1-Trichloroethane and 1,1-Dichloroethylene .
- Some of the site’s key documents of interest are accessible below:
- Environmental Indicator Determination - Human Exposure[PDF, 9 pages, 227KB, About ]
- Environmental Indicator Determination -Groundwater[PDF, 8 pages, 126 KB, About ]
- Documents and reports regarding this facility also can be reviewed in person at these locations:
U.S. EPA Region III
Land & Chemicals Division
1650 Arch Street-11th Floor
Philadelphia, PA 19103
Call for an appointment.
- Submit a FOIA Request
Get instructions on how to submit a FOIA request. Additional fee for requests over 100 pages.
|Kennametal Manufacturing -Bedford|
Click on a thumbnail to enlarge the photo)
The site is under continued use.
The EPA is dedicated to providing you with timely and accurate information about our work at this site. If you have any questions or concerns, please contact EPA Project Manager: Mr. Andrew Clibanoff (215) 814-3391.