RCRA REVISION CHECKLIST 125

Boilers and Industrial Furnaces;
Changes for Consistency with New Air Regulations
58 FR 38816-38884
July 20, 1993
(RCRA Cluster IV, HSWA/non-HSWA provisions)

Notes:  1)  The final rule addressed by this checklist was promulgated pursuant to the Clean Air Act, rather than the Resource Conservation and Recovery Act, and primarily amends regulations in 40 CFR Parts 51 and 52.  However, this rule also makes conforming changes to 40 CFR Parts 260 and 266 to ensure that the guidelines for air quality modeling and screening for boilers and industrial furnaces burning hazardous waste are consistent with the guidelines in 40 CFR Part 51.  Only the changes to 40 CFR Parts 260 and 266 are included in this checklist.  These revisions are necessary.  Therefore, this checklist has been developed to help States maintain consistency with the Federal regulations.  Note that States do not have to adopt the changes to 40 CFR Parts 51 and 52 to make the Part 260 and 266 changes.  Rather, States should reference Appendix W, Part 51 at 266.104(e)(3) and 266.106(h).

2)  Note that EPA's Office of Solid Waste is treating the changes made by the Air rule to 40 CFR Parts 260 and 266 as HSWA provisions because they amend the BIF regulations promulgated under HSWA.

	FEDERAL REQUIREMENTS	FEDERAL RCRA CITATION	ANALOGOUS STATE CITATION	STATE ANALOG IS:				
				EQUIV-ALENT	LESS
STRIN-
GENT	MORE STRIN-GENT	BROADER IN SCOPE	
	PART 260 - HAZARDOUS WASTE MANAGEMENT SYSTEM:  GENERAL							
	SUBPART B - DEFINITIONS							
	REFERENCES							
	revise reference to "U.S. EPA, Screening Procedures for Estimating the Air Quality Impact of Stationary Sources" to refer to the October 1992 version	260.11(a)						

	PART 266 - STANDARDS FOR THE MANAGEMENT OF SPECIFIC HAZARDOUS WASTES AND SPECIFIC TYPES OF HAZARDOUS WASTE MANAGEMENT FACILITIES							
	SUBPART H - HAZARDOUS WASTE BURNED IN BOILERS AND INDUSTRIAL FURNACES							
	STANDARDS TO CONTROL ORGANIC EMISSIONS							
	change wording to refer to Appendix W, Part 51, methods rather than Appendix X, Part 266, methods; change wording to reflect updated 260.11(a) reference; remove "on-site" after "average" in last sentence	266.104(e)(3)						
	STANDARDS TO CONTROL METALS EMISSIONS							
	change wording to refer to Appendix W, Part 51, methods rather than Appendix X, Part 266, methods; change wording to reflect updated 260.11(a) reference	266.106(h)						
	APPENDIX X TO PART 266							
	GUIDELINE ON AIR QUALITY MODELS (REVISED)							
	remove text; change title to "Appendix X--Removed"	266, Appendix X