NATURAMA G3 A-5. National Contingency Plan Product Bulletin
TECHNICAL Product Bulletin #SW-53
Original listing date: JANUARY 26, 2011
“NATURAMA G3 A-5”
| I. Name, brand, or trademark |
|---|
| NATURAMA G3 A-5 Type of Product: Surface Washing Agent |
| II. Name, address, and telephone number of manufacturer/contact |
|---|
| Green Life Development, Inc. 5112 W. Charleston Boulevard, Suite C Las Vegas, NV 89146 Phone: (702) 966-1284 Mobile: (702) 355-5102 Fax: (702) 448-6977 E-mail: david@greenlifedevelopment.com (Mr. David A. Levy) |
| Merlin-Tao Ltd. 65 Yigal Alon St. POB 91 Tel Aviv, Israel 67443 Phone: 972-3-562-8020 Fax: 972-3-562-8021 E-mail: asaf@merlin-tao.com (Mr. Asaf Yari, CEO) |
| III. Name, address, and telephone number of primary distributors |
|---|
| Green Life Development, Inc. 5112 W. Charleston Boulevard, Suite C Las Vegas, NV 89146 Phone: (702) 966-1284 Fax: (702) 448-6977 E-mail: info@greenuses.com (Mr. David A. Levy) |
| IV. Special handling and worker precautions for storage and field application |
|---|
| 1. Flammability: Non-flammable (DOT: Non-hazardous) 2. Ventilation: No special requirements. 3. Skin and eye contact; protective clothing; treatment in case of contact: No special equipment or clothing is required; however, goggles are recommended. If eye or skin irritation occurs, flush with plenty of water. 4.a. Maximum storage temperature: 120°F continuous, 140°F up to 5 days 4.b. Minimum storage temperature: 35°F 4.c. Optimum storage temperature range: 40°F to 120°F 4.d. Temperatures of phase separations and chemical changes: Stable |
| V. Shelf life |
|---|
| NATURAMA G3 A-5 has unlimited shelf life in sealed poly drums. |
| VI. Recommended application procedure |
|---|
| 1. Application Method: Product may be applied by any method (e.g., drum pump, pressurized spray applicator, brush, or aqueous wash tank), depending on the surface; and type and viscosity of the oil/contamination to be treated. 2. Concentration/Application Rate: The dilution ratio depends on the amount and type of contamination to be removed. For light contamination areas a 1:6 dilution ratio (product to fresh/salt water) with a 2-3 minutes wait. For heavier/thick/burnt contamination, the exact ratio should be determined by the field coordinator but a general starting point of 20-25% should remove most contamination (grease, burnt oil, diesel, tar, etc.) after a contact time of 10-15 minutes before rinsing with water/steam. 3. Conditions for Use: Cleanup residue must be collected and should be disposed of in accordance with local, state, and federal regulations. Where possible, the product/oil mixture can be recovered and processed using an oil separator system or a stagnant tank. A circulating wash tank fitted with an oil separator or filter system extends the life of NATURAMA G3 A-5 by weeks, greatly impacting the waste reduction. |
| VII. Toxicity and effectiveness | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
a. Toxicity:
b. Effectiveness: |
| VIII. MICROBIOLOGICAL ANALYSIS |
|---|
| NA |
| IX. Physical properties |
|---|
| 1. Flash Point: >93°C 2. Pour Point: +28°F 3. Viscosity: 1.3628 cst @ 40°C 4. Specific Gravity: 1.006 @60°F 5. pH: 8.39 6. Surface Active Agents: PROPRIETARY 7. Solvents: PROPRIETARY 8. Additives: None 9. Solubility: Miscible in oil, water, and solvents |
| X. Analysis for heavy metals, cyanide, and chlorinated hydrocarbons | ||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|